Chelsio Communications Chelsio T4 Podręcznik Użytkownika Pobierz pdf (Strona 147)

Chapter IX. FCoE Full Offload Initiator

iv. Enabling DCBX:

switch(config)# interface ethernet 1/13

switch(config-if)# priority-flow-control mode auto

switch(config-if)# flowcontrol send off

switch(config-if)# flowcontrol receive off

switch(config-if)# lldp transmit

switch(config-if)# lldp receive

switch(config-if)# no shutdown

v. On the FC Ports, if a FC target is connected then perform the following steps -

switch(config)#vsan database

switch(config-vsan-db)#vsan 2

switch(config-vsan-db)# vsan 2 interface fc 2/2

switch(config-vsan-db)#exit

switch(config)interface fc 2/2

switch(config-if)# switchport mode auto

switch(config-if)# switchport speed auto

switch(config-if)# no shutdown.

vi. If you have not created a zone then make sure the default-zone permits the VSAN created,

             

switch will not talk to each other. To enable it, execute the below command.

switch(config)# zone default-zone permit vsan 2

4.1.3. Configuring the Brocade 8000 switch

i. Configure LLDP for FCoE.Example of configuring LLDP for 10-Gigabit Ethernet interface.

switch(config)#protocol lldp

switch(conf-lldp)#advertise dcbx-fcoe-app-tlv

switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 373 374

Brak uwag

Chelsio Communications Chelsio T4 Podręcznik Użytkownika Strona 147