
Chapter I. Chelsio Unified Wire
Chelsio T5/T4 Unified Wire For Linux Page 28
viii. The selected components will now be installed.
After successful installation you can press 1 to view the installation log. Press any other key
to exit from the installer.
ix. Reboot your machine for changes to take effect.
3.2.2.1. iWARP driver installation on Cluster nodes
Chelsio’s Unified Wire package allows installing iWARP drivers on multiple Cluster nodes with a
single command. Follow the procedure mentioned below:
i. Create a file (machinefilename) containing the IP addresses or hostnames of the nodes in
the cluster. You can view the sample file, sample_machinefile, provided in the package to
view the format in which the nodes have to be listed.
ii. Now, execute the following command:
[root@host] # ./install.py -C -m <machinefilename>
iii. Press ‘1’ to read the Chelsio End User License Agreement; Press ‘q’ to go back to
installation menu. Press ‘2’ to Accept the EULA and start the installation or ‘3’ to Disagree
and and exit from the installer.
iv. Select the required T5/T4 configuration tuning option. The tuning options may vary
depending on the Linux distribution.
v. Select the required Cluster Configuration.
vi. If you already have the required version of OFED software installed, you can skip this step.
To install OFED-3.5 choose the Install-OFED option. To install a different version, select
Choose-OFED-Version and then select the appropriate version. To skip this step, select
Skip-OFED.
To install Bypass or WD-TOE driver, run
[root@host]# ./install.py -c <target> and follow steps (iv) - (vi)
mentioned above.
To customize the installation, view the help by typing
[root@host]#./install.py –h
Please make sure that you have enabled password less authentication with ssh
on the peer nodes for this feature to work.
High capacity RDMA and High capacity TOE options are currently not
supported with T5 Adapters.
Komentarze do niniejszej Instrukcji